← Back to Projects

Bluetooth Robot Car

Arduino-powered robot car controlled from a React Native mobile app via Bluetooth.

Project Overview

This project combines an Arduino-based robot car with a Bluetooth module (HC-05/HC-06) and a React Native controller app. The phone connects over classic Bluetooth and sends simple text commands to drive the car.

Arduino Firmware

Reads Bluetooth serial commands like F150 or L200 and controls the motors through an L298N driver.

  • Board: Arduino-compatible
  • Bluetooth: HC‑05 / HC‑06 (SPP)
  • Driver: L298N dual H-bridge

Mobile Controller

A React Native app (Android) built with react-native-bluetooth-classic provides connect, speed, and directional controls.

  • Platform: React Native CLI
  • Connects to: HC‑05 / HC‑06
  • Commands: Forward, Backward, Left, Right, Stop

Hardware Setup

Wire your components as described below. Adjust pin numbers in the Arduino sketch if you change the wiring.

Required Components

  • Arduino (Uno / Nano or similar)
  • HC‑05 or HC‑06 Bluetooth module
  • L298N motor driver board
  • 2x DC motors + chassis + wheels
  • Battery pack (with common ground to Arduino)

Example Pin Mapping

  • ENA: 5 (PWM)
  • IN1: 8, IN2: 9
  • ENB: 6 (PWM)
  • IN3: 10, IN4: 11
  • HC‑05 TX/RX → Arduino RX/TX (with level shifting as needed)

See arduino/RobotCar.ino in the repository for the exact firmware.

Bluetooth Command Protocol

The phone sends simple text commands over Bluetooth serial. Each command is terminated with a newline (\n).

Commands

  • F<speed> – forward (0–255)
  • B<speed> – backward (0–255)
  • L<speed> – turn left
  • R<speed> – turn right
  • S – stop
  • V<speed> – set base speed

Example

F150\n  → drive forward at speed 150
L120\n  → turn left at speed 120
S\n    → stop the car

React Native App

The controller app is located under react_native/RobotCarRN/ in the repository. It discovers a bonded Bluetooth device named HC-05, HC-06, or BT-CAR and sends the commands above.

  1. Install dependencies with npm install (or yarn).
  2. Connect your Android device and enable USB debugging.
  3. Run npm run android inside react_native/RobotCarRN.
  4. Pair your phone with the HC‑05/HC‑06 in system settings, then tap “Connect” in the app.

Get Started Locally

  1. Clone or download this repository to your computer.
  2. Flash the Arduino sketch at arduino/RobotCar.ino.
  3. Pair your phone with the HC‑05/HC‑06 Bluetooth module.
  4. Run the React Native app on Android and start driving your car.

This website is a static overview only; Bluetooth control is provided by the native app, not the browser.